When the flux starts to bubble, solder the fitting onto the pipe. Thread the connector into the transition fitting; tighten the connector with pliers and an adjustable wrench.
How to Connect a Refrigerator Water and Ice Dispenser
Take the flexible water-supply tubing from the back of the refrigerator and feed it down through the hole in the floor. Brush pipe dope onto the cone-shaped ground joint connection. Thread the nut on the tubing end onto the compression connector soldered to the cold-water supply line.
Tighten the nut with pliers and an adjustable wrench.
Propane torch
Connect the tubing to the valve by hand, then turn one extra time with a wrench. Turn the water on to flush the tube into a pail for at least 1 quart or until the water runs clear.
- free dating in perth western australia!
- How to Connect a Refrigerator Water and Ice Dispenser | This Old House!
- online dating flirting sites!
- How to Hook Up a Water Line to a Refrigerator | HowStuffWorks!
Shut off water at the new valve. Connect the ferrule and pressure nut to the hose at the refrigerator end. Attach the nut to the refrigerator valve.
How to Install a Refrigerator Water Line | www.thelongevityrevolution.com
If applicable to your refrigerator, run the tubing through the hose clamp to hold it at the preferred angle. Plug in the refrigerator.
Set the ice maker to the "on" position as indicated in your specific model. Discard the first two or three batches of ice to flush the system.
- how to get a date on a dating website!
- who invented radiocarbon dating!
- dating site jp!
- Added to Cart.
- How to Connect a Refrigerator Water and Ice Dispenser.
- How to Install a Water Line for a Refrigerator Ice Maker | Home Guides | SF Gate!
- Warranty & Support.
- Tools List for Connecting a Refrigerator Water and Ice Dispenser.
- How to Hook Up a Water Line to a Refrigerator From the Sink | Home Guides | SF Gate!
- Propane torch.
- dating parker knoll chairs!
- archaeomagnetic dating problems!
Consult local plumbing codes to be sure what you do is permitted; for instance, saddle valves are not allowed by Massachusetts building codes. Thomas Ferraioli began writing in His work has been featured in national publications like "Parents" and "U.
Help Library
Skip to main content. Tapping the Cold Water Line Shut off the main water supply to your home.
Brush pipe dope onto the cone-shaped ground joint connection. Thread the nut on the tubing end onto the compression connector soldered to the cold-water supply line. Tighten the nut with pliers and an adjustable wrench.
Turn the water back on and test the water dispenser in the refrigerator door. Skip to main content. Get the latest news, updates and offers from This Old House to your inbox.